Stripper Slayer - Diablo

Restore's Stripper Slayer (DIABLO) is the Reaper’s heavy-duty finisher...built to burn through layers of dirt, grease, paint, and sealer like they never existed. This industrial-strength stripper is engineered for wood, concrete, asphalt, and fiberglass shingles, cutting through multiple layers of buildup fast and rinsing clean in both hot and cold water.

When you’re staring down layers of old stain, stubborn paint, or deep-set grime, Restore's Stripper Slayer (DIABLO) doesn’t flinch...it attacks, penetrates, and emulsifies everything standing between you and a bare, clean surface.

Whether you’re restoring a deck, prepping a slab, or stripping a nightmare left by someone else, Restore's Stripper Slayer (DIABLO) makes one promise: EVERYTHING COMES OFF!

Caustic Sodium Hydroxide - Deck Stain & Heavy Duty Coating Remover.

Directions for Use

Works in Cold Water

• Pre-wet the entire surface thoroughly and broom out puddles.
• Apply with a low-pressure sprayer.
• Let dwell for 5–10 minutes...enough time for the chemistry to bite.
• For multiple paint layers or heavy coatings, agitate with a stiff brush and reapply as needed.
• Do not use on polished or anodized aluminum.
• Never allow product to dry...always rinse thoroughly.

Rinse with low pressure for wood (to avoid damage) and high pressure for concrete or masonry.

Always apply from bottom up and rinse top down on vertical surfaces.

Dilution Ratios

• Full strength to 1:3 → stripping thick coatings
• 1:2 to 1:4 → general heavy cleaning
• 1:10 → roof/asphalt shingle use
• 1:40+ → safety dilution if near aluminum or painted surfaces